INSTALLATION INSTRUCTIONSFOR SU SPORTSTER KIT(1041-0062, 1041-0063, 1041-0064)Fits Carbureted EVO XL ModelsCongratulations on your purchase of the “Ki
Carb body and throttle cables installed and secure.Install ‘pull’ throttle cable into cable guide & rotor.It may be necessary to run he cable adju
Guide dome over the piston return spring to compress it. Dome will fit on body only one way, so insure that bolt holes in the dome line up exactly to t
Hand tread the breather bolt into the front head breather bolt hole. Do not tighten yet.Secure the dome to the body with the three slotted screws.Its
Make sure that the hose and plastic fitting are not interfer-ing with the carburettor linkage in any way. Tighten both breather bolts into the heads.Me
Su Carb installed less air cleaner assembly.Installing the air cleaner starts with the installation of the straight hose connector (1101-0005) into th
Now secure the air cleaner backing plate onto the SU carburettor with the (4) bolts and star washers included in the air cleaner kit. Tighten all (4)
Install air cleaner cover with element and mesh screens onto the backing plate so that the two studs fit into the holes in the backing plate and the SU
Slide the last hose clamp over the hose with the worm screw out and facing down. Tighten the hose clamp. (It is recommended to use an in-line fuel filt
LIMITED WARRANTYThis product is covered by a limited warranty that it is free from defects in material and workmanship, and against exces-sive wear fo
Prior to beginning the actual install, we recommend that you remove the Dome & Piston from your new SU carb to help make the install easier.Remove
Install the manifold flange and seal on both outlets on the manifold. NOTE: The flanges are marked (F) for front intake and (R) for rear intake.Install
Slide manifold onto (2) rear manifold intake flange bolts you peviosusly installed.Tighten Front manifold intake flange bolts.(2) front manifold intake
Place the lower carb support (1042-0231) on top of lifter block inside bolt hole on each lifter block.Hand thread each bolt into the lifter base holes
Prepare to install the upper carb support (1133-1004).Tighten the two OE lifter base bolts to secure the lower carb support.Use a hex head bolt (1100-
Secure the upper & lower carb supports with a flanged lock nut (1100-0034).Now tighten the two rear intake flange 12 pt bolts with a 12 pt curved wr
Place throttle cable guide (1042-0003) in front of the carb body, flat side up lined up with the two top bolt holes.Hang the carb intake gasket (1094-0
Tighten both bolts & nuts.Slide two hex head bolts (1100-0045) into the two top carb holes from the back with the threads facing toward you.Cable
Kommentare zu diesen Handbüchern